Python 671XP Manual do Utilizador descarregar pdf (Página 13)

Page notification

The remote control can be programmed to notify the user of a

page (audibly beeping if the vehicle’s status changes, e.g. door

unlocked, engine started, vehicle violation, etc.). Press to

select page On/Off. One beep is page On, Two beeps is page Off.

When programmed off the remote will not give any notification

that a page was received from the vehicle.

To exit programming mode

The remote control will exit programming mode after 2-seconds

of inactivity and will emit 2 long beeps.

uussiinngg yyoouurr ssyysstteemm

The buttons used in the instructions in this manual correspond

to the standard configuration. Remember, this is not the only

way your 2-way remote may be set up. It can be custom config-

ured to meet your needs.

active arming

You can arm the system by pressing of your 2-way remote

for one second. When the system arms, from the vehicle you will

hear a short siren sound, or chirp, and see the parking lights flash

once. If the power door locks are controlled by the system, the

doors will also lock. While the system is armed, the in-vehicle’s

status LED will flash approximately once per second, indicating

that the system is actively protecting your vehicle. If you hear a

➜

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 42 43

Sem comentários

Python 671XP Manual do Utilizador Página 13